第 7 步：当我们更改事件内部的命令时，我们会更改发生碰撞时发生的情况。
- 删除读取的命令····精灵。去到（ 0，0 ）
现在，当 UFO 接触到另一个精灵时，该精灵会隐藏，但 UFO 不会发生任何事情。
To navigate the page using the TAB key, first press ESC to exit the code editor.
第 7 步：当我们更改事件内部的命令时，我们会更改发生碰撞时发生的情况。
现在，当 UFO 接触到另一个精灵时，该精灵会隐藏，但 UFO 不会发生任何事情。
To navigate the page using the TAB key, first press ESC to exit the code editor.
Your micro:bit is not set up for this program. Follow these steps to use your device with Codesters:
Your micro:bit has an old version of the Codesters binary file. Follow these steps to update the file on your micro:bit:
Warning: This will erase any existing program on your micro:bit.
Having trouble? Check out the micro:bit instructions to update your firmware.
Setting up your micro:bit
Calibrate your micro:bit by tilting it until all the LEDs are lit.
For a demonstration see the micro:bit calibration instructions.
Try the following steps to connect to your Micro:bit:
1. You may need to reload this page and try your program again.
2. Try disconnecting and reconnecting your Micro:bit. Then reload the page and run your program again.
3. If you are still having problems your Micro:bit may have an old firmware version that is incompatible with Codesters.
To update the firmware follow these Micro:bit instructions.
Are you already running a Codesters project in another tab or window?
Micro:bit can only connect to one web page at a time. Try stopping other Codesters projects or closing other tabs or windows that may be using your Micro:bit.
If that doesn't fix the problem try disconnecting your Micro:bit, reloading this page, and reconnecting your Micro:bit.
Status: Connected!
Status: Connecting...
Status: Still connecting...
Status: Failure
Status: Not Found
Is your Micro:bit connected?