你的目标:重新创建一个著名的标志。 从下面的链接中选择1个标志。
实用链接:可以重新创建的品牌标志, 示例 1, 示例 2, 示例 3
注释:尝试写自己的注释!在代码行开头输入一个#,然后输入你选择重新创建的名称和公司标志。你的注释应该变灰。
To navigate the page using the TAB key, first press ESC to exit the code editor.
你的目标:重新创建一个著名的标志。 从下面的链接中选择1个标志。
实用链接:可以重新创建的品牌标志, 示例 1, 示例 2, 示例 3
注释:尝试写自己的注释!在代码行开头输入一个#,然后输入你选择重新创建的名称和公司标志。你的注释应该变灰。
To navigate the page using the TAB key, first press ESC to exit the code editor.
Your micro:bit is not set up for this program. Follow these steps to use your device with Codesters:
Your micro:bit has an old version of the Codesters binary file. Follow these steps to update the file on your micro:bit:
Warning: This will erase any existing program on your micro:bit.
Having trouble? Check out the micro:bit instructions to update your firmware.
Setting up your micro:bit
Calibrate your micro:bit by tilting it until all the LEDs are lit.
For a demonstration see the micro:bit calibration instructions.
Try the following steps to connect to your Micro:bit:
1. You may need to reload this page and try your program again.
2. Try disconnecting and reconnecting your Micro:bit. Then reload the page and run your program again.
3. If you are still having problems your Micro:bit may have an old firmware version that is incompatible with Codesters.
To update the firmware follow these Micro:bit instructions.
Are you already running a Codesters project in another tab or window?
Micro:bit can only connect to one web page at a time. Try stopping other Codesters projects or closing other tabs or windows that may be using your Micro:bit.
If that doesn't fix the problem try disconnecting your Micro:bit, reloading this page, and reconnecting your Micro:bit.
Status: Connected!
Status: Connecting...
Status: Still connecting...
Status: Failure
Status: Not Found
Is your Micro:bit connected?