检查理解：让我们再看看那些符号！
我们使用 if 语句来测试两个事物何时相等，但我们也可以使用它们来比较值。
大于：如果您的猜测>随机数，精灵会说： "Nope! Too high!"
小于：如果您的猜测<随机数，则精灵会说： "Nope! Too low!"
To navigate the page using the TAB key, first press ESC to exit the code editor.
检查理解：让我们再看看那些符号！
我们使用 if 语句来测试两个事物何时相等，但我们也可以使用它们来比较值。
大于：如果您的猜测>随机数，精灵会说： "Nope! Too high!"
小于：如果您的猜测<随机数，则精灵会说： "Nope! Too low!"
To navigate the page using the TAB key, first press ESC to exit the code editor.
Your micro:bit is not set up for this program. Follow these steps to use your device with Codesters:
Your micro:bit has an old version of the Codesters binary file. Follow these steps to update the file on your micro:bit:
Warning: This will erase any existing program on your micro:bit.
Having trouble? Check out the micro:bit instructions to update your firmware.
Setting up your micro:bit
Calibrate your micro:bit by tilting it until all the LEDs are lit.
For a demonstration see the micro:bit calibration instructions.
Try the following steps to connect to your Micro:bit:
1. You may need to reload this page and try your program again.
2. Try disconnecting and reconnecting your Micro:bit. Then reload the page and run your program again.
3. If you are still having problems your Micro:bit may have an old firmware version that is incompatible with Codesters.
To update the firmware follow these Micro:bit instructions.
Are you already running a Codesters project in another tab or window?
Micro:bit can only connect to one web page at a time. Try stopping other Codesters projects or closing other tabs or windows that may be using your Micro:bit.
If that doesn't fix the problem try disconnecting your Micro:bit, reloading this page, and reconnecting your Micro:bit.
Status: Connected!
Status: Connecting...
Status: Still connecting...
Status: Failure
Status: Not Found
Is your Micro:bit connected?